1u” steps the parameter X from 0.1u to 0.3u in 0.1u increments. 3u” steps the parameter X through each value listed.Įxample B: “.step param X. step command via a SPICE directive that specifies the steps for the parameter by a linear, logarithmic or list of values.Įxample A: “.step param X list. The addition of the curly braces around the variable is important as it tells LTspice IV that “X” is a parameter.
step command causes an analysis to be repeatedly performed while stepping through a model parameter, global parameter or independent source.
step command to sweep across a range of values in a single simulation run. There are two ways to examine a circuit in LTspice by changing the value for a particular parameter: you can either manually enter each value and then resimulate the circuit to view the response, or use the. STEP Command to Perform Repeated Analysis